I haven’t really had a need for vertical, but now do. I guess I would need to do the same for a known ground elevation also but just don’t know how to get that known ground height? I know I can also use FG to LOCALIZE to Northing and Easting coordinates in the field. I can load a GEOID for my region also, but I want to know the actual vertical GROUND elevation of my property at each of the 4 corner points? But it still reads vertical based on WGS84. I can also do this in MicroSurvey FieldGenius (FG) and assign NAD83 or a State Plane coordinate system for Northing and Eastings instead of Lat Long. How do I get the actual GROUND ELEVATION reading of each of those property points using ROVER? Not just the ellipsoid height, but the physical ground elevation? Do I have to locate a KNOWN point close by in the area as a reference or control point then the rest base from there? How do I get the known coordinates and actual ground elevation that matches that known physical point so I can load it into the BASE? It records my LLH (or XYZ) using WGS84 in METERS. So say I measure the points using ReachView Survey. I know ReachView uses WGS84 ellipsoid for vertical height.įor the sake of simplicity, I’ll measure 4 points of my property boundary using a Reach RS ROVER and a Reach RS BASE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |